RIP Configuration on Juniper

In this lesson, we will configure Juniper routers for RIPv2. RIP is the simplest Routing Protocol and configuring RIP on Juniper Routers need a couple of simple steps. We will see each of these steps one by one. For our Juniper RIP Configuration Example, we will use the below topology. Now, let’s focus on the Juniper RIP Configuration steps and start our RIP configuration.

Step 1 – IP Address Configuration

Firstly, we need to configure all the interface addresses as given above. The IP connectivity is the first must, to configure RIP or any other Routing Protocol. We can do IP configuration with the below command set: Router 1

Juniper-Router1@Kosem> configure
Juniper-Router1@Kosem# set interfaces ge-1/1/1 unit 0 family inet address 10.0.10.1/30
Juniper-Router1@Kosem# set interfaces ge-1/1/2 unit 0 family inet address 10.0.20.1/30

Router 2

Juniper-Router2@Kosem> configure
Juniper-Router2@Kosem# set interfaces ge-1/1/1 unit 0 family inet address 10.0.30.1/30
Juniper-Router2@Kosem# set interfaces ge-1/1/2 unit 0 family inet address 10.0.10.2/30

Router 3

Juniper-Router3@Kosem> configure
Juniper-Router3@Kosem# set interfaces ge-1/1/1 unit 0 family inet address 10.0.20.2/30
Juniper-Router3@Kosem# set interfaces ge-1/1/2 unit 0 family inet address 10.0.30.2/30

Step 2 – Routing Policy Configuration

Here, we will configure a Routing Policy that will accept RIP learned and Directly connected Networks. Our Policy name will be RIPPolicy. [sc name=”ContentRMessage”] Other RIP Lessons Routing Information Protocol – RIP Overview Routing Information Protocol – RIP Configuration With Packet Tracer Routing Information Protocol – RIP Configuration on Juniper Routing Information Protocol – RIPng Overview Routing Information Protocol – RIPng Confiugration on Cisco IOS Routing Information Protocol – RIPng Configuration on Huawei Dynamic Routing Protocols