VLAN Routing with Layer 2 Switch and Router on Huawei

Huawei VLAN Routing with Layer 2 Switch is done with the help of a Layer 3 device, a router. Mainly, in the router, in layer 3, gateways are created for the VLANs. These gateways are the subinterfaces under the physical interface. For each subinterface, an IP address is assigned.   Our VLAN Routing Configuration example topology is below: Let’s do the required configuration for Huawei VLAN Routing on Switch and Router.

Switch Configuration for VLAN Routing

  On Huawei switch, firstly we will configure the VLAN interfaces. We will set link-types of this interfaces as access and we will set its default vlan.   [Huawei-Switch] interface GigabitEthernet0/0/1 [Huawei-Switch-GigabitEthernet0/0/1] port link-type access [Huawei-Switch-GigabitEthernet0/0/1] port default vlan 10 [Huawei-Switch-GigabitEthernet0/0/1] quit [Huawei-Switch] interface GigabitEthernet0/0/2 [Huawei-Switch-GigabitEthernet0/0/2] port link-type access [Huawei-Switch-GigabitEthernet0/0/2] port default vlan 20 [Huawei-Switch-GigabitEthernet0/0/2] quit [Huawei-Switch] interface GigabitEthernet0/0/3 [Huawei-Switch-GigabitEthernet0/0/3] port link-type access [Huawei-Switch-GigabitEthernet0/0/3] port default vlan 30 [Huawei-Switch-GigabitEthernet0/0/3] quit   We will configure the router face interface of the switch as “trunk” and we will configure it to allow all vlans. If you want to allow only specific VLANs, it allows only these VLANs.   [sc name=”ContentRMessage”]